Page 1 of 1
RCM Proof Set Holders
Posted: Wed Feb 20, 2019 12:33 pm
by Loyalist
I have RCM proof sets from 1988-1993 and am trying to figure out how to remove the sleeve without destroying the binding edge. I am trying to scan the sleeves and am finding it awkward while they are still in the the binding.
Any suggestions would be appreciated.
Re: RCM Proof Set Holders
Posted: Thu Feb 21, 2019 9:05 am
by coinguy
Simple, they were made to remove.
Turn case over so Queens head faces up.
On the right hand side of the plastic case
you will see two little grooves. Place a small
screwdriver in there and pop the case out.
It snaps back in just as easily.
Re: RCM Proof Set Holders
Posted: Thu Feb 21, 2019 10:35 am
by Loyalist
Tks. Coinguy. Noticed the slots before but was uneasy about trying. Worked well and I did not see any damage.
Found that my 1986-1988 sets did not have the slot but was able to get my finger nails under the frame which came up pretty easily. Got much better scans of the coins in the sleeves. Once again thank you.